A:-flow
B:-drying
C:-thixotrophy
D:-set-off
B:-drying
C:-thixotrophy
D:-set-off
Correct Answer:- Option-C
2:-Which of the following additive will improve the rub resistance of ink ?
2:-Which of the following additive will improve the rub resistance of ink ?
A:-resin
B:-wax
C:-drier
D:-extenders
B:-wax
C:-drier
D:-extenders
Correct Answer:- Option-B
3:-The colour appears to run, the fountain solution and dampening rollers become tinted - Bleeding is caused due to
A:-excessive driers
3:-The colour appears to run, the fountain solution and dampening rollers become tinted - Bleeding is caused due to
A:-excessive driers
B:-insufficient water at the plate
C:-the pigment is hydrophilic
D:-insufficient water at the plate
Correct Answer:- Option-C
4:-Yellow is often printed above the magenta and cyan but if opaque yellow is used the order of yellow printing is
4:-Yellow is often printed above the magenta and cyan but if opaque yellow is used the order of yellow printing is
A:-first colour
B:-second colour
C:-third colour
D:-fourth colour
B:-second colour
C:-third colour
D:-fourth colour
Correct Answer:- Option-A
5:-The release of individual small fibers, particles from paper surfaces is termed as
5:-The release of individual small fibers, particles from paper surfaces is termed as
A:-Greasing
B:-Fluffing
C:-Strippring
D:-Tinting
B:-Fluffing
C:-Strippring
D:-Tinting
Correct Answer:- Option-B
6:-Printing one side of the sheet, then turning the sheet over, retaining the same front and side-lay edges of the sheet and the same printing plate can be done by
A:-Work and tumble
6:-Printing one side of the sheet, then turning the sheet over, retaining the same front and side-lay edges of the sheet and the same printing plate can be done by
A:-Work and tumble
B:-Work and twist
C:-Work and turn
D:-Full sheet work
D:-Full sheet work
Correct Answer:- Option-C
7:-Which of the following is not the cause of image dot gain during plate making process ?
7:-Which of the following is not the cause of image dot gain during plate making process ?
A:-over exposure
B:-incomplete plate development
C:-poor vacuum frame contact
D:-changing the position of the lamp during exposure
B:-incomplete plate development
C:-poor vacuum frame contact
D:-changing the position of the lamp during exposure
Correct Answer:- Option-B
8:-Which of the following is not a quality control aid ?
8:-Which of the following is not a quality control aid ?
A:-star target
B:-dot gain scale
C:-FOGRA strip
D:-gripper mark
Correct Answer:- Option-D
B:-dot gain scale
C:-FOGRA strip
D:-gripper mark
Correct Answer:- Option-D
9:-To facilitate the order of each signature into its correct sequence within the book which of the following is used?
A:-Gathering
B:-Collating
C:-Imposition
A:-Gathering
B:-Collating
C:-Imposition
D:-Sequencing
Correct Answer:- Option-B
10:-A solution applied to offset plate and dried to produce a hydrophilic film on the non-image area to prevent image area from spreading
A:-fountain solution
10:-A solution applied to offset plate and dried to produce a hydrophilic film on the non-image area to prevent image area from spreading
A:-fountain solution
B:-water
C:-gum arabic
C:-gum arabic
D:-addhesiver
Correct Answer:- Option-C
1 Comments
Good mcqs. I liked it.
ReplyDeletePost a Comment